This file contains the following components.
- boost files (to adjust speed)
- software (to customize the controller)
To install the software, you need the following.
Other information:
- The riser cable can be purchased via our portal via this link.
- The part for remote-controlled tuning can be purchased via our portal via this link.
Manual
Please note! There are different performance files for a Bosch motor and for non-Bosch motors. The only difference in this manual is step 7.
- Data: black/green/yellow
- Current: black/orange
Step 1: Connect the large white plug to the controller, which is located under the storage compartment.
Step 2: Plug the USB data cable into the computer.
Step 3: Go to the folder on the computer and open ProgrammerCore.
Step 4: Next, press LOGIN (you do not need to enter a user code or password).
Step 5: Check the following (Ignore Cus.) and press OK.
Step 6: Select the correct port and click on FILE, then on LOAD FROM LOCAL ZIP FILE. Do you want to know which port you need? Then unplug the data cable. When you plug the data cable back in, you will see it appear in the dropdown.
Step 7: Open the correct folder on the computer and select the correct boost file with the desired speed. Make sure you upload the zip file. Attention! Select the correct performance files for the motor, i.e., with or without Bosch.
Step 8: Plug the USB power cable into the computer's USB port with the power icon (see photo below).
Step 9: The following appears: the controller is now being updated.
Step 9: When you see the following, the controller has been updated; close the program before disconnecting your USB cables.
The controller has now been updated with the new software.