This file contains the following components.
- performance files
- reset files
- Linbo upgrade tool (software to customize the controller)
Other information:
- The booster/reset cable can be purchased via our portal via this link.
- The part for remote-controlled tuning can be purchased via our portal via this link.
Manual
The easiest way is to first adjust the speed using the plug. If that doesn't work, you can adjust the speed by modifying the software.
Tuning with plug:
Please note! The controller must be set to 45 km/h before you can use this manual. There are occasional deliveries where the controller is already set to 25 km/h software. In that case, 45 km/h software must first be installed on the controller before the modes can be used.
- 25 km/h - plug disconnected
- 35 km/h - black & white plug together – remove blue-white cable from the white plug (do not cut, tape off cable)
- 45 km/h - plug together
- 55 km/h - use the software
Boosting with software:
Tuning is possible when the controller is still attached to the scooter with the battery, or when you remove it using power from the computer.
Step 1. First download the files and save them to your computer:
Step 2. Connect the plug to the controller. There are 3 USB plugs on the other end of the cable.
- Current
- Data
- Data
Step 3. Now connect the USB cable (transparent gray) to the computer in a USB port with a power icon (see photo below).
Step 4. You can now open the software using the program below.
Step 5. The program then opens. In this program, select the correct port. After that, click Load File in the upper right corner.
How do you know which port to use? When you connect the cable to the computer, it appears in the dropdown list of available ports.
Step 6. You can now select the boost file with the desired speed. From the reset controller folder.
Step 7. The program will then load the file.
Step 8. Click on upgrade until a second line appears. Like the image below.
Step 9. Connect USB cable 2 to the computer (USB cable connected with yellow/green/red wiring).
Step 10. Connect USB cable 3 to the computer (USB cable connected with black and red wiring).
Step 10. The update is starting. Please wait until it is finished. This may take a few seconds. If the upgrade is successful, you will see the image below. And the controller is ready.
You can now disconnect the cables. Always test whether the update was successful before putting the covers back on.
Below is an additional video with an explanation.